Recommendations 

How do I setup my Cisco router for the first time?

Kobe Glover

How do I setup my Cisco router for the first time?

To configure the initial router settings by using the setup command facility, follow these steps:

  1. Set up a console connection to your router, and enter privileged EXEC mode.
  2. In privileged EXEC mode, at the prompt, enter setup.
  3. To proceed using the setup command facility, enter yes.

How do I setup my Cisco router to the Internet?

Router setup steps

  1. Step 1: Decide where to place the router.
  2. Step 2: Connect to the Internet.
  3. Step 3: Configure the wireless router gateway.
  4. Step 4: Connect gateway to router.
  5. Step 5: Use app or web dashboard.
  6. Step 6: Create a username and password.
  7. Step 7: Update the router’s firmware.
  8. Step 8: Create a Wi-Fi password.

How do I reset my Cisco 800 Series router?

Reset Router Using Reset Button

  1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
  2. Find the Reset button on the router.
  3. Press and hold the Reset button while you power on the router.
  4. Release the Reset button after 10 seconds.

How do I connect to my router?

Step 1: Swipe a finger down from the top to expand the Notification Shade and tap the Cog icon. Step 2: With the Settings panel open, tap Network & Internet. On Samsung phones, tap Connections instead. Step 3: Tap Wi-Fi.

How do I connect my wireless router to my computer?

Connect a PC to your wireless network

  1. Select the Network or icon in the notification area.
  2. In the list of networks, choose the network that you want to connect to, and then select Connect.
  3. Type the security key (often called the password).
  4. Follow additional instructions if there are any.

What is router configuration?

Configure your router to make your network complete. You need to configure the router so that it can communicate with your network components. You don’t need to adjust the firewall; most routers set things up just as you need them. Set a Service Set Identifier, or SSID, for your wireless network.

How do I clear all settings on a Cisco router?

Clear the configuration of your switch

  1. Log on to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
  2. Enter clear config all to reset the entire system. You don’t need to reload the switch because processing the command wipes the switch.

Where is the Reset button on Cisco router?

Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

What is the IP address for my router?

Find your Router’s IP address on Android Go to Settings > WLAN. Click the details icon. Then you could find your Router’s IP address show as Gateway.

Can a Cisco 867vae show controller VDSL 0?

R1-C867VAE>show controllers vdsL 0 – this below confirms that i have some connection to my ISP via DSL. Modem Status: TC Sync (Showtime!)

How to configure an over POTS Cisco router?

Configuring ADSL2/2+ Annex M mode on Over POTS VDSL2/ADSL Multimode Annex A SKUs. This chapter provides procedures for configuring the basic parameters of your Cisco router, including global parameter settings, routing protocols, interfaces, and command-line access.

What are the ports on a Cisco 890 router?

Table 1 lists the interfaces that are supported for Cisco 860, 880 and 890 series routers and their associated port labels on the equipment. When you first boot up your Cisco router, some basic configuration has already been performed.